You will now see your VPN network adapter.Next, we need to change the VPN Network adapter, to enable MS Chap v2.Fill in the username and password that we created.Enter the pre-shared key that we have set earlier in the UniFi Console.VPN Type > Select L2TP/IPSec with pre-shared key.Enter the public IP Address of your UniFi Console.Enter a connection name, it can be anything you like.Select Windows (built-in) as VPN provider.Open Start and type VPN and select VPN Settings.The steps below are the same on Windows 10 and 11. To use the VPN connection on Windows you don’t need to install any clients. Strong Authentication is needed for the MS-Chap v2 protocol that is used by Windows 10 and 11.įirewall rules are automatically created for the Remote access VPN, so we don’t need to look at them. But more important is to set your internal DNS server and enable Require Strong Authentication. Here you can change the subnet if you need. Set the advanced configuration to Manual. ![]() Click on Create a new user and enter a username and password. The next step is to create a new VPN user. Make sure that the Server Address is set to your Public IP Address In the UniFi network app, go to Settings > VPNĮnable the VPN Server and note or change the Pre-shared Key ![]() If that isn’t possible, then you will need to forward the following port numbers to your Unifi Network console: This way all traffic will be forwarded directly to your Unifi Network. ![]() If you have a modem or router before your UDM or USG, then make sure that the modem/router is set into Bridge mode. Also, make sure that you run the latest firmware on your console. To configure the UniFi VPN you will need to have a UDM model or a USG.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |